How do I vary the channel capacity (PHY Data Rate) for nodes running IEEE802.11 Protocol? : NetSim Support Portal

How do I vary the channel capacity (PHY Data Rate) for nodes running IEEE802.11 Protocol? Print

Modified on: Thu, 22 Jul, 2021 at 3:33 PM

Applicable Versions

NetSim Academic

NetSim Standard

NetSim Pro

Applicable Releases

v11

v12

v13

NetSim supports the following IEEE802.11 standards

1. 802.11b, the channel bandwidth is 20MHz. Provides 11 Mbps transmission (with a fallback to 5.5, 2, and 1-Mbps) in the 2.4 GHz band.

2. 802.11a, the channel bandwidth is 20MHz. Provides up to 54-Mbps in the 5GHz band.

3. 802.11g, the channel bandwidth is 20MHz. Provides up to 54-Mbps in the 2.4 GHz bands.

4. 802.11n, the channel bandwidth is 20, 40MHz. Builds upon previous 802.11 standards by adding multiple-input-multiple-output (MIMO).

5. 802.11ac, the channel bandwidth is 20, 40, 80, 160MHz. Operates only in the 5 GHz frequency range and

features support for wider channels (80MHz and 160MHz) and beamforming capabilities.

Users can choose between these standards in the Wireless Node properties as shown below:

Did you find it helpful? Yes No

How do I vary the channel capacity (PHY Data Rate) for nodes running IEEE802.11 Protocol? Print